PCWL-04XX
- What is the maximum distance between mesh Access Point(AP)s?
- Is it possible to use power over Ethernet (PoE) with the LAN cable?
- What is the weight of the PCWL series?
- ●How can I use the 4.9GHz band for backhaul?
- ●Is it possible to use IP phones with PCWL?
- What is the power consumption of PCWL?
- I would like to add PCWL to the whitelist controlled by the upper-level network, what MAC address should I add?
- ●I would like to know about the QoS settings that can be configured in PCWL.
- What is the maximum distance between mesh APs?
- Can PCWL products be used overseas?
- Is the IPoE method supported for IPv6?
- Does PCWL supports 802.11k?
- Can PCWL affect medical equipment?
- If the backhaul is not used, is it safe to remove the backhaul antenna?
- Are there any requirements for the installation of the service?
- Does it work in a proxy environment?
- Are there any requirements for the devices that can be connected?
- What is the guaranteed operating humidity range?
- Are there any restrictions on Internet access?
- Can I use SNS authentication, such as LINE or Facebook, when connecting to Wi-Fi?
- Is it possible to provide Internet for office visitors?
- Is it possible to check the status of Wi-Fi access?
- How many wireless multi-hops are possible?
- How many endpoints can be connected to one Wi-Fi access point device? And how many devices can be connected at the same time?
- Where should the Wi-Fi access point (PCWL) be installed? Are there any installation points?
- Is it possible to counceling the location of the Wi-Fi access point?
- Is it possible to connect indoor and outdoor models with mesh?
- How large an office can be covered by one Wi-Fi access point device?
- The PicoHUB series is housed in a case. Will the signal from the antenna be attenuated?
- How many units can be configured in a mesh network?